A8 Rear Customer Display Installation Guide

A8 4689 Till Rear Display Installation Guide:

To install the A8 rear display you will need
 

1x Phillips head screwdriver
1x A8 Rear display
 2x A8 Rear Display screws

To start you must remove the tills rear panel, there are 2 screws that will need to be removed, keep them safe as you will need them to reattach the rear panel later.

This is the rear Panel of the A8 4689 till, the two screws can be seen at the bottom of the panel, to remove the panel once the screws are removed lever the panel of the till by using a screwdriver in the screw holes.

Remove the access port of the rear panel, this will be used to thread the wire into the till cable space and attach the display using the screws provided.

This is the A8 Rear display, there will be a notch where the cable comes out, it is important the notch is always on the bottom side of the till if not the display will be upside down.

Thread the rear display wire through the access port.

Put the rear display flush with the rear panel.

Once the rear panel display is flush with the back panel, screw the panel in place with 2 screws supplied left and right of the cable hole (recommended to use the outer holes)

This is the cable on the till you will have to attach the rear display to, it will be protruding from the top of the IO panel of the till.

The rear display cable will be attached as in the photo above. Once this is done you must place the back panel on the back of the till and reattach it to the till using the screws removed at the start of the process.

Once this installation is complete inform the MyAPPetite Support Team this has been done and an engineer will apply the software integration for the display.

If you have any questions regarding any of our guides, please call the myAPPetite Support Department on 01562 270009 or 07842375283. 

Please note the Support Team office hours are Monday – Friday 9am - 5pm. 

For Critical Support they are available from Monday – Friday 5pm – 9pm & over the weekend between 9am – 5pm. 

Critical Support is only classed as the following:

• Unable to take online orders
• EPOS isn’t working
• Critical to operation failures

Any other requests will be dealt with within the next working day. Please be aware that within our SLA Agreement you will have a response within 2 hours.